The Ampair 600 is the latest micro wind trubine from Ampair. Built on the same platform as the renowned Ampair 100 and the newer Ampair 300 it has a 1.7m (about 5.5 ft) diameter blade optimized for low and medium speed winds. It incorporates the PowerFurl system which slows the turbine down inn high winds, reducing noise and mounting system loads. 

For 24 or 48 Volt Battery Charging. Must be installed with Voltage Regulator (available below)

Range of mounting options

Regulator for Ampair 600 Wind Turbine, 50 amps x 24 volts (or 48 volts for 48 volt model).

Includes the regulator, rectifier, dump load, stop switch, fuses, meter, RS-232 ports, wind input, reverse polarity protection.

24 and 48 volt models

Pivot bearing set for Ampair 100 for 2001 model and onwards (aka "Pacific" model), Ampair 300 and 600.

Upper and lower bearing, O-ring and spiral lock ring.

Set of 3 slip ring brushes

Pivot Seal for Ampair 100, 300 and 600 Wind Turbines.

Neoprene V-seal, seals gap between pivot and pole.