Ampair 300 Voltage Regulator

12 and 24 volt models

Set of 3

Matched set of 2 turbine blades for pre 2001 Ampair 100 Wind Turbines (aka "Hawk" model)

Matched set of 2 turbine blades for 2001 model and onwards Ampair 100 Wind Turbines (aka "Pacific" model)

Rectifier assembly and heatsink.

Also suitable as emergency spare in case of regulator failure. 

Set of 3 slip ring brushes

Complete, pre-wired rectifier assembly. Consists of 2 bridge rectifiers. For all A100 models.  

Pivot bearing set for Ampair 100 pre 2001 model (aka "Hawk" model).

Upper and lower bearing, O-ring and spiral lock ring.

Pivot bearing set for Ampair 100 for 2001 model and onwards (aka "Pacific" model).

Upper and lower bearing, O-ring and spiral lock ring.

Upper and lower bearing, O-ring and spiral lock ring.

Shaft bearings (set of 2) for Ampair 100 Wind Turbine (all models).

Set of 2 slip ring brushes

Nylon locking left hand hex nut, washer, dowel pin and cap

Pivot Seal for Ampair 100, 300 and 600 Wind Turbines.

Neoprene V-seal, seals gap between pivot and pole.

Shaft Seal for Ampair 100 (all Models)

Rubber covered, single lip seal protects front bearing.