The Ampair 600 is the latest micro wind trubine from Ampair. Built on the same platform as the renowned Ampair 100 and the newer Ampair 300 it has a 1.7m (about 5.5 ft) diameter blade optimized for low and medium speed winds. It incorporates the PowerFurl system which slows the turbine down inn high winds, reducing noise and mounting system loads. 

For 24 or 48 Volt Battery Charging. Must be installed with Voltage Regulator (available below)

Range of mounting options

The Ampair 100 is an efficient, very quiet, vibration-free, wind driven alternator. Mounted on a stern pole or on the mizzen mast. With it's six blades, it has zero vibration and is completely silent. It never needs to be battened or shut down. The Ampair will not throw a blade in even the most extreme wind. This is truly a worry-free, trouble-free generation device.

Ideal for severe remote locations with low power requirements. 

Regulator for Ampair 600 Wind Turbine, 50 amps x 24 volts (or 48 volts for 48 volt model).

Includes the regulator, rectifier, dump load, stop switch, fuses, meter, RS-232 ports, wind input, reverse polarity protection.

24 and 48 volt models

Stainless steel cage to protect propeller form larger debris.

Ampair Voltage Regulator for all 100 watt wind and water turbines. 

12, 24 and 48 volt models.

Single and triple output models for 1-3 battery banks.